Updating firmware on a v240 xian lim dating valerie
It does not support 100Mb/s or faster hubs or switches, and does not support 10Base-T full-duplex mode.The IP address assigned to it is a unique IP address, separate from the main Sun Fire server IP address, and is dedicated for use only with the ALOM system controller.
The Instrument Transformer Correction module is a core module that allows customers to correct for inaccuracies in the current transformers (CTs) and potential transformers (PTs).
We will help you determine if you are running the required HBA firmware revisions and Solaris Patch Releases to support 300GB disk drives in your V240.
We can offer up to a .00 per drive credit for each drive you trade-in.
NOTE: The speed bumped 1.34GHz and 1.5GHz Sun Fire v210 and Sun Fire v240 systems require a minimum of Solaris 8 HW 02/04, Solaris 9 09/04, or Solaris 10. WARNING: In the Sun Fire V440, Sun Fire V250 and Netra 440 servers that use an ALOM System Controller Card, daughter cards marked with part number 501-6346-06 (or higher, not -01 through -05) absolutely require ALOM release 1.4 or later. You can connect an external ASCII terminal to the serial management port (SERIAL MGT) and start using ALOM right away without needing to configure the ALOM software.
NOTE: Netra 440 and Sun Fire V440 servers with Motherboard part number 501-6910 (or replacement FRU 540-6336) requires ALOM release 1.5. Using an ALOM version below 1.4 could damage the new ALOM System Controller Card. For more information about connecting an external terminal, refer to the Installation Guide that came with your host server. What is the speed of the ALOM network management port? The ALOM network management port is a 10BASE-T (10 Megabit per second Twisted Pair Ethernet) port that operates in half-duplex mode only.
Note: ALOM can also be referred to as the: "system controller", "system management controller","remote management controller”.